Timing Belt Change

[maryswells]

Can anyone tell me at what mileage this change should be made. Typically on a Honda Civic say. It would be around 100,000 miles per the manufacture's Specs. Would this hold true for a mini truck.

[daveintheburbs]

I believe is 80,000km or about 48k miles. better to do before it breaks. Anyone buying a high milage truck should ensure this was already done

[maryswells]

Thanks for the info.

[daveintheburbs]

Well that is what I get for going from memory. I hit the manual this morning and it is 100,000 KM or 60,000 miles for the OEM replacement schedule. Still important to check on high mileage trucks.

[JRinTX]

Speaking of timing belt changes... can folks post a description of what was involved if they changed a timing belt? Sort of a step by step guide for their particular truck.

I know that I would be interested in instructions for a Suzuki. If you can post the make of the truck and instructions, we can all benefit! And pics would be nice...:p

[daveintheburbs]

For a susuki to boot. If some one can take on a translation I will shoot you a PDF

[DRW]

Please send me the PDF file for the Suzuki.

[Don-in-Japan]

You can mail me a copy as well...I'll post it in my galleries with the other translated files. Thanks!

[kargador]

For a susuki to boot. If some one can take on a translation I will shoot you a PDF

sir, I would like to request a copy of this PDF. Thanks.

lornatek@yahoo.com

[etownminitrucks]

Hello.
I'm working on a customer truck (96 Suzuki) with very uneven compression. (40/70/10 lbs). Belt was replaced 50,000 km's ago but it already feels a tad "sloppy".
This truck has been used hard. My initial thought is that it skipped time, as it fires but doesn't run on it's own.
Can anyone tell me if these are interference engines and, if so, will there be damage if the timing belt slips 1 tooth?
Would such a timing issue alone explain the difference in compression?

I would love a copy of this PDF as well!

Thanks!

Simon
Etownminitrucks.com (http://www.etownminitrucks.com)

[Don-in-Japan]

These are without a doubt interference engines. Others may have their own opinions, but I don't think a tooth will make a difference. I inherited my Carry from a guy who lost his timing belt, then after replacing 2 valves, put cam timing about 45 degrees off, and proceeded to rebend the valves he just replaced. :frustration:

You'll surely loose compression as well.. re-align the belt, and test the compression again.

[etownminitrucks]

Thanks for your advice!
However, I can't really make heads or tails of the timing marks.
Does anyone know of a good illustration/instruction for this procedure? (Maybe the above mentioned PDF-file...?)
And the bolt for the alternator-pulley, is that a left-hand thread or conventional? I assume it requires an impact wrench for removal even with such limited space.

[Don-in-Japan]

Hey..I just found the PDF file. PM me your Email address, and I will send it. It is still in Japanese though.. I haven't had time to translate.

I haven't run into a reverse thread yet on my Carry. All should be conventional. I assume you mean the crank pulley, and unless you have a way to brace the pulley from spinning, you'll probably need an impact wrench.

[etownminitrucks]

Done! :)
I'll ask one of my Japanese colleagues to translate.