1991 Mitsu front disc specs?

[pogue]

Hello. New to the forum and glad to be here.

I need the manufacturers front disc brake minimum thickness specifications.

Can anyone help?:frustration:

[Subaru]

should be stamped on the inside of rotor,usually covered by rust:frustration:
Sambar spec is 16.0 mm

[pogue]

Thanks Subaru. I had a feeling you were going to say that.

Where in Alberta are you? I am in Edmonton.

[Subaru]

The big metropolis of Airdrie:D

[slimbad]

pogue, i don't know if this will be the same for your vehicle but here are the specs out of a 1989 Mits service manual for the U.S. version LHD 4WD

minimum thickness of:

front disc: 9.4 mm (.370 in)

front disc pads: 2.0 mm (.79 in)

rear brake lining (shoes): 1.0 mm (.039 in)

MAXIMUM I.D. rear brake drum: 205 mm (8.1 in)

again this is for U.S. marketed Mits. hope this helps.......later, slim

[Subaru]

pogue, i don't know if this will be the same for your vehicle but here are the specs out of a 1989 Mits service manual for the U.S. version LHD 4WD

minimum thickness of:

front disc: 9.4 mm (.370 in)



Wow-looks like your fronts are solid and not vented,or else really small:)

[pogue]

Thanks Slim. I need this information to show the mechanic to get my Mitsu road licensed. Do you have a copy that you could email or fax me?

[pogue]

Pulled the disc off last night. Same 9.4mm spec as Slim mentioned.

[slimbad]

Pogue, sorry it took sooo long to post back - had some scanner issues, hope these help.........later, slim

701

702


If you can't see these clearly PM me and i'll email them to you w/ higher resolution.

[pogue]

Thanks Slim.

I sent you a PM.

pogue.