Search:

I own one of the Mighty Mits LH drive models, I believe some of these don't even have a gear there, this is one of the few times I would really like to find out I am wrong.

Setting one of these up now in a Mits, my distributor has 6 poles on the chopper wheel, so I am assuming it has three lost sparks per revolution, no reason the 6 cylinder setting would not work...

Well I got the carb dialed in and the ignition started acting up, this seems to be a vicious cycle. I have an MSD 6al on the way and am busy modding the other distributor for the MSD. My plan is to...

Well after fooling with the stock carb for about two weeks on and off I have had enough. I located a Harley CV carb on Ebay FOR $85.00 shipped, it just got here today. I was looking around in my...

Do you sell those fenders separately and if so how much?

Its a 3G83 I could use a reluctor out of one if you want to part with it LMK.

I found the plate you are referring to , no need to go any farther the 7th digit is a P, no fourth gear for me.:frustration:

Mine is a 94 2wd, i looked today the 7th digit was an o. Since it is 2wd I can't go off of your photos too much as they are quite different.

Okay something you said in another thread got me thinking Dan, you said that on some trucks the J909 was used to operate the tach . So a little research dug up a tach signal divider- converter from...

I am new here so I my ideas don't carry much weight but I find all the stickys kinda bothersome, maybe a separate sticky section that would expand out at the top of the page?

I was doing some fiddling with the transmission on the Mitsu to see if it did indeed have a fouth gear, I was able to remove the tailshaft and found a circilp which reduced the travel on one of the...

I have been looking at the same thing, only on a two wheel drive version.Which means I don't have to worry about the cv axle clearance. The problem I saw was where the steering links bolt to the...

You may be correct on it counting the pulses, if so I know of no way to reconfigure that. I do know it will not signal to fire without the pulse from the J909, whether or not the pulse has to be...

I have been studying the schematics you posted a link to Dan, I am thinking if the correct value zener diode is placed in series on the yellow wire coming out of the j909 ignition module on the side...

Well its been running for a couple of weeks,today I pulled the rear of the tranny apart and removed the circlip on the shift rod so it now has four gears. I buttoned it all back up cranked it up and...

anyone or am I on my own here? :confused:

Part came in today and truck is back running after cleaning the carb and draing the old fuel however the clutch is not working, I may have it drivable tomorrow.

The reason I am asking is I have severe rust problems on both my trucks. The Cushman parts site shows some body panels available such as the door sills and a front floor section, if they are even...

Pull the piece out and see if you can get a part number off of it , then do a google search for that part number, I did this yesterday on the Lefty Ignitor and came up with several sources for the...

Yes that is the piece I was referring to.

If its a right hand drive truck try G&R imports.

Okay after a few hours of searching I located the part, and actually found one on Ebay with a pic, its an exact match. Below is what I found it also fits, maybe someone else can use this information....

I am a new member and am from Alabama, I own two 94 model Mitsubishi mini cabs . I have had them for a few years and look forward to repairing them this winter.:D

I am looking for an ignition control unit that attaches to the side of the distributor on this engine, I have heard that one can be obtained through a Mitsubishi car dealer but have been unable to...