1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Started my 93 mits lift

Discussion in 'Mitsubishi Minicab' started by Gooseman, Sep 12, 2013.

  1. Gooseman

    Gooseman New Member

    Well I started to build a lift for my minicab. I decided to drop the trans down 2 1/2 inches and then do a 4" coil spring spacer. So far so good got the front done now to work on the back. I welded up all the spacers and made the offset spacers to fit the coil springs and keep the tire camber as straight as possible. Also had to extend the steering linkage some.
     

    Attached Files:

  2. muddy moose

    muddy moose Member

    Looks good!! I just cut my crossmember and lowered the center then welded the drop brackets there. Pretty cool to see all the ways different people do theirs. 4 wasn't enough for me. 7 isn't either........ Soon will be taller Hahaha. Good luck!! Are you going to do a shackle drop or flip the rear axle under the spring? I'm doing both. But I have a Suzuki carry....... Not that that makes a difference Hahaha
     
  3. 93mit

    93mit Member

    I used wrist pins out of a engine, 1066 IH

    To make the spacers to lift mine and then

    used some more of them to drop the crossmember

    It worked out to be about 3"
     

Share This Page