1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Lift question

Discussion in 'Daihatsu Hi jet' started by cdover73, May 19, 2014.

  1. cdover73

    cdover73 Member

    This is the spacer on my lift. It is slanted to one side, I guess to allow for camber correction. It measures 2 1/2" on the short side and 3" on the long side. I want to make an even cut through the center to remove X amount to shorten it and reweld the halves back together, but I need to know what this is actually considered. Is it a 2 1/2" lift, which is what the guy I got the truck from told me it had, or is it 3"? I want to get it down to 2" or maybe even 1 3/4" so I don't wear out my new cv joints.

    Sorry the pic is a little blurry. I shake a lot.....
     

    Attached Files:

  2. cdover73

    cdover73 Member

    Well, I should wait before I post. I just talked to G&R and he said it is considered a 2 3/4" lift and I should be fine with it. I was going to delete the post but figured I would leave it up for future reference.
     

Share This Page