First off I am new to the site and it is awesome. Bought my first mini a couple months ago. 1996 Suzuki 4wd I have read and read til my eyes are going to fall out. Here is what I am going to do: afco 225 lbs springs and an adjustable camber 2" lift kit put approximately a 1" spacer in the rear trans crossmember same spacer in engine crossmember and also front cradle will figure out torsion arms but probably knock out studs and put spacer in between swing arm and rod with bolts this should in all respects mimic a body lift---will adjust steering linkage if needed to avoid disrupting arch next put axle underslung of rear springs and weld new perches and accommodate if driveline length is disturbed new brackets for e brake and make own shackles for rear axle to level truck did I miss anything