Step Up Exporters and Dealers!!!!!

[xroadsimport]

Sorry guys I guess next time I will take the time to run the spell checker or not.

[zbadboy]

Everybody can fat finger the key board. However, when you spell the word twice within two words of each other.....Priceless!!!

[Mighty Milt]

you gotta add some points for consistency!!

[Mini4WD]

I've called my dealer in Emporia Va and left several messages in regards to a truck that was purchased from there. I've sent an email asking for a response and still no one has called me back or responded to my emails.

I wouldn't waste my time on that dealer from Emporia Va if it is who I think it is. They will not call you back no matter how many times you call or email them. I also ran into a problem with my truck that came from them. They never would call me back either. There is a lot of info here on this site and several dealers on this site that are more than willing to help. Good Luck with your truck.

[cajun666]

thank you for this great post

I am not going to be as nice as the previous posts. You have allot of nerve jumping on here claiming "MANY" dealers on here do not provide you with any service. You were smart enough to figure out how to post a response I am asuming you are smart enough to search the site as well.

OK now I will be nice. This is info I have collected off this site. There are no quarantees these will work. Use at your own risk.

Batteries

NAPA 8223

Interstate Batteries
YB30L-B
SYB16L-B
YB16CL-B

Autozone has a 425 AMP lawnmower battery that works great. You have to convert to blade posts and alter your clamp system a bit, but that is too easy. I believe it is about $26. Be sure to take your old battery to avoid the core charge.

Oil Filters

Oil filter for carry is a wix 51344 Fram 4967

Mitsubishi Wix 51365 or Fram 1365 NAPA 1365

Fram PH6607 interchanges to Wix 51365.

Daihatsu Wix 51394 Walmart Super Tech ST7317

More cross reference. The Baldwin filters have a good name as a quality U.S. made filter.
The B1400 is the cross over for the standard short filter (length 2 5/8" - M20 X 1.5mm threaded).
B1402 will work on some trucks although a bit longer at 3.5" and finally the B1431 is the longest at 4" long.
These are direct cross overs for several of the Mitsubishi filters as listed on their web site.

Gear/Transmission Oil

My Japanese Mitsu owner's manual calls out "SAE 75W/85W (GL-4)" for both the transmission and transfer case. For the differential, SAE 90 above 10 degrees C, SAE 80W below 10 degrees C. it calls for 0.73 qts. of 75w-85 0r 90w depends on temp. Differential-front 0.83qts. 80w-90
rear 1.34qts. 90w.

Use 70 weight gear lubes in std. tranny & diffs. Not the heavy stuff






Engine Oil

10w30 or 10w40

Suzuki - 660cc Oil Filter Air Filter Spark Plugs
Napa FIL1360 Denso XU22EPR-U
Wix 51360
Daihatsu - 660cc Oil Filter Air Filter Spark Plugs
Napa FIL1360 Denso K20PR-U11
Wix 51360
Mitsubishi - 660cc Oil Filter Air Filter Spark Plugs
Napa FIL1356 K&N  33-2740 Denso K20PR-U11
Wix 51356 Mitsubishi OEM MD620584

Spark Plugs

GENERAL RULE OF THUMB, PLUGS CAN BE SET A .035 THOUSANDS ON MOST MAKES.

Ngk#dcpr7e Nipondenso #xu22epr-u

Plug: NGK#BKR-68 Mitsubishi

NGK #BKR6E-11 in my 95 mitsubishi

93 Mitsubishi Autolite 3923s


Suzuki F5A and F6A NAPA# 3932
DAIHATSU EF 660 AUTOLITE# 64
HONDA HA4 660 NAPA 6962
SUBARU KS 660 AUTOLITE# 5224








Shocks

shocks are Monroe 3100's

Daihatsu: Monroe part #32207

Mitsubishi: Napa Respose #94009
NAPA # 94009 on the rear for my Mitsubishi with a 3 inch lift worked out great.

Suzuki: We have yet to find the part #. We can make shocks fit but prefer to find some that will fit without any modifications to the truck.

Can anybody give us the part # for the Monroe 3100 shocks (rear shocks)for a Suzuki Carry?

Air Filter

Mitsubishi MD620584 and MR571470 cross reference to a K&N Part # 33-2740



here the actual tuneup parts I used on my 92 suzuki carry hope it helps
Air Filter Fram CA568
Fuel Filter WIX 33470
Oil Filter NAPA 1360 / WIX 51360
Spark Plug NGK DCPR7E / NGK 3932

2001 Suzuki Carry F6A engine 657cc

Water pump/alternator belt NAPA #25-7300

Same belt also fits power steering

Tires/Wheel

The only tire we recommend for the stock wheel is the carlisle 23x7x12 ACT

12x7 wheels with a 5+2 offset and 4/115 bolt pattern should work for your '90 Suzuki

Bolt Pattern Lug Size
Suzuki 4 x 115mm (older models) 4 x 100mm (newer models) 12mm x 1.25
Daihatsu 4 x 110mm 12mm x 1.5
Mitsubishi 4 x 115mm 12mm x 1.5

13 inch wheels off a 1'st gen mazda rx 2-3-7 will bolt right up 4x110 Daihatsu

toyota tercel seem to be 100 on 4 suzuki carry

The 4/115 fitting on a Suzuki is only good for all trucks older than 1994, and half the 1995 trucks. Half the 1995 trucks and anything 1996 and newer will take a 4/100 hole pattern.

5+2 offset needed for the mini trucks

175/70-13 gives you a theoretical diameter of 575.2mm = 22.6"

175/65-14 gives 583.1mm = 22.9".

4 on 100mm (3.93")
Acura - Integra to '89
Audi - most models to '89
Audi Fox
BMW 1600, 2002
BMW - 2002, 300-series to '89
Chevy - Chevette '76-'87
- Spectrum, Nova '80-'89
Dodge - Omni, Rampage, Aries, 024 '79-'85
- Charger, Daytona (FWD) '82-'89
Honda - all (except '76-'80 Accord, Civic) to '89
Isuzu - Impulse, I-Mark to '89
Nissan - Pulsar, Sentra '87-'89
Opel Kadett
Plymouth - Horizon, TC3, Reliant, Voyager '78-'89
Renault - all to '89
Toyota - Celica, MR2, Tercel '86-'89
VW - Dasher, Fox, Jetta, Rabbit, Scirocco to '89

The stock steel rims from the 1997 Nissan Sentra (13x5) fit perfectly--4x100 bolt pattern and the center bore fits snugly also

Shop Manual

Nagata Technology,Inc. 847-439-0321 Daihatsu s81p, s82p-s83p-s110p $65.00+ship

I have a 1992 suzuki carry 660. Any parts store can get air, oil filters, and belts. part number for AIR FILTER is WIX #42143 or NAPA SILVER #22143 . OIL FILTER part number is WIX #51360 or NAPA 1360. SPARK PLUG number is NGK #DCPR7E. ON your belt take it with you and they can match it. Oil I used ROTELLA 15W 40


Does anyone know if the valves are adjustable on a 93 hijet and iff so what they should be set at?

INtake-0.18mm
EXhaust-0.25mm ALL SET COLD

Driveline Parts

shaft U-joint in a 94 Diahatsu

neapco # 1-0011

Valve Specs

the valve specs for a Suzuki F6A 660cc engine Cold engine, .003 intake,.006 exhaust

The mitsu's spec at; .006" in .009" ex (cold) and .008"in and .012"ex (hot)

Valve lash - Subaru KS4
Cold setting

Intake .15mm +/- .02mm (.0059 in +/- .0007 in)
Exhaust .20mm +/- .02mm (.0078 in +/- .0007 in)

Mitsubishi CV Boots
napa part no. 686-1188

Fluid Level

Mitsubishi

Engine oil - 2.9 qts (less filter).

Coolant system - 3.9 qts (including heater and coolant reserve tank). Use any high quality Ethylene Glycol antifreeze/coolant. (also look under the raised portion of the driver seat for coolant refill instructions (if you have an open/close position valve on ur radiator neck) this will prevent air pockets/blocks.

Manual transmission - 2.5 pints (Hypoid gear oil 80w or 75w-85 conforming to API spec GL-4 or higher)

To check the tranny - remove the filler plug (midway on side of tranny oil shud be up to the lower edge of hole). If you desire to drain - there's a drain plug on bottom of tranny. (recommend a new gasket for drain plug)

Front axle - 1.5 pints (85w-90)

Rear axle - 2.3 pints (85w-90)

Fuel tank - 7.9 gals

Brake fluid DOT 3 as needed (to check lift up the very left hand flat panel on dash - to the left of steering wheel).

Belts

93 Suzuki Alternator belt 13250 or 14-0837-8

The brand on these ones are "power torque".

U-Joints

NAPA PUJ410 is an exact replacement for diahatsu u-joints.

[tob]

NOW THATS WHAT I CALL STEPPING UP!!!

Thanks Zbadboy! I'll have to print that!

AMEN to that...

[j6hf]

NOW THATS WHAT I CALL STEPPING UP!!!

Thanks Zbadboy! I'll have to print that!

Ya know it's amazing how some people just want to help , others just want to be in the camera. Thanks for taking the time Zbadboy to help us out ! great job.