Click to view all our sponsors
Results 1 to 5 of 5

Thread: Carquest part# DD51t

  1. #1
    Join Date
    May 2009
    Location
    James Bay Frontier
    Posts
    1,410
    Rep Power
    7

    Default Carquest part# DD51t

    ...


    I've started this thread for specific vendor #'s. Feel fee to add HERE if you have some specific Carquest #s and instalation compatablity for the DD51t.
    Carquest parts are CHEAP!

    Thermostat (180deg) #31978
    FIT: 10/10 - No need to modify, already has the "blead hole".

    Thermostat Gasket #20971
    FIT: 9/10 - The two mounting holes need to be tightend up slightly. 3mm closer to the center, for both holes, easy. One side has peel-off glue, other side needs sealant of some kind. (I use "High Tack")

    Air Filter #87143
    FIT: 9/10 - No need to modify, length is correct but filter must be "centered" in the housing before locking it down with the cap. It will stay centered once it's all tight, but housing must be removed it accomplish this.

    Fuel Filter #86470
    FIT: 8/10 - No need to modify. I replaced both "above gas tank" fuel filters with this type. Very close to originals, has larger capacity for one of them and some lines are one size too small for the connectors. I took the rubber lines off the truck (they are short) and added some grease to the filter nipples. Lines can be forced on with a little effort and then installed back on to the truck. Original filter mounts work at a lower position on the new filters.

    Upper main coolent line @ thermostat housing # RBR 22323
    FIT: 10/10 - fully molded coolant hose, use new hose clamps as side wall is thicker, heavy duty, hose must be cut in half length, producing 2 replacement lines, one spare, fit is perfect.

    Air box relocation/modification hoses
    Carburator to air box, consisting of 1 90deg bend in mid length of 2" rad hose with spring insertion, preventing colapsing under vacuum # RBR 21378
    FIT: 8/10 - cut to length and fit is good enough to use, or not, hose clamps.

    Use same above part # for exit pipe, as snorkel. fit is perfect and no cutting is required. String tie to side of box when in use, about 8" higher than box side.

    Air box to under bed connection # RBR 25530
    FIT: 10/10 - for a relocated air box, perfect fit from air box to bed rail connection, use hose clamps or not, fit is that good. Flexable/coragated line with spring insertion to prevent colapsing under vacuum.


    ...
    Last edited by spaner; 09-22-2011 at 04:14 PM.
    93 Carry DD51T...4WD, EL+5up, Rear-Diff-Locker, A/C, PWR Windows, 2" Exhaust, 1 3/4"-Afco Lift, OS-NB-WIX, K&N-Master-Lung, F-MTC-by-Jamar, Front-Slider-by-Tivar...
    Interceptor 3.0; Stage 3 [14PSI BOOST]...

  2. #2
    Join Date
    May 2009
    Location
    James Bay Frontier
    Posts
    1,410
    Rep Power
    7

    Default

    ...


    Previous post additions, of coolent line hose and air box relocation and snorkel hoses. PVC sucks



    Attached Images Attached Images
    93 Carry DD51T...4WD, EL+5up, Rear-Diff-Locker, A/C, PWR Windows, 2" Exhaust, 1 3/4"-Afco Lift, OS-NB-WIX, K&N-Master-Lung, F-MTC-by-Jamar, Front-Slider-by-Tivar...
    Interceptor 3.0; Stage 3 [14PSI BOOST]...

  3. #3
    Join Date
    Dec 2011
    Posts
    1
    Rep Power
    0

    Default Carquest part# DD51t

    I think, that you are not right. Write to me in PM.
    buy azithromycin no prescription nedeed fast shipping-Zithromax 1000 mg

    buy zithromax 1000 mg-Zithromax where to buy

  4. #4
    Join Date
    Mar 2010
    Location
    Fallbrook Cal.
    Posts
    535
    Rep Power
    5

    Default

    Thanks spaner I used these numbers for thermo,thermo gasket and, most importantly for me, the upper hose which fits perfectly. Napa # for the hose is 8956 if anyone needs to know.

  5. #5
    Join Date
    May 2009
    Location
    James Bay Frontier
    Posts
    1,410
    Rep Power
    7

    Default

    I guess we could add the camber-correction bolt numbers and the tranny sensors (#) to that list as well.

    Sure would be nice if the Suzuki reference section could be policed/organized a little better, but...

    The guys that want to find, can though.
    93 Carry DD51T...4WD, EL+5up, Rear-Diff-Locker, A/C, PWR Windows, 2" Exhaust, 1 3/4"-Afco Lift, OS-NB-WIX, K&N-Master-Lung, F-MTC-by-Jamar, Front-Slider-by-Tivar...
    Interceptor 3.0; Stage 3 [14PSI BOOST]...

Similar Threads

  1. OEM Part number or compatable part number required
    By mikeh1975 in forum Subaru Sambar
    Replies: 1
    Last Post: 02-25-2012, 03:41 AM
  2. Help Need a Part
    By ukpaul in forum Suzuki Carry
    Replies: 1
    Last Post: 10-14-2009, 07:27 AM
  3. part
    By louis westernoff in forum Subaru Sambar
    Replies: 2
    Last Post: 09-30-2008, 07:48 AM
  4. Need a part
    By benny in forum Wanted
    Replies: 1
    Last Post: 08-22-2008, 04:57 PM
  5. Need a part
    By benny in forum Mitsubishi Minicab
    Replies: 1
    Last Post: 08-22-2008, 03:20 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •